Y. Martele

Ab initio and experimental study on thermally degradable polycarbonates: Effect of structure on reactivity

V. Van Speybroeck, M. Waroquier, Y. Martele, E. Schacht
International Journal of Quantum Chemistry
91(3), 363-368
2003
A1

Abstract 

The thermal degradation process of some new synthesized polycarbonates is studied both from theoretical and experimental points of view to obtain microscopic insight into the factors that govern the reaction rates. Ab initio density functional theory calculations are performed on a set of carbonates, which are model systems for the polycarbonates. Kinetic parameters are determined by transition-state theory and compared with experimental-derived degradation temperatures. The study as presented here gives evidence of the existence of a correlation between these degradation temperatures and the reaction rates resulting from static ab initio calculations on small model systems that are representative for the active area of the degradation process. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem, 2003

Thermodegradable polycarbonates: Effect of substituents on the degradation temperature

Y. Martele, V. Van Speybroeck, M. Waroquier, E. Schacht
E-Polymers
049
2002
A1

Abstract 

The thermal degradation process of some new polycarbonates is investigated from an experimental and theoretical point of view, in order to obtain insight into the microscopic aspects that influence the reaction mechanism and the process of thermolysis. In particular, attention is focussed on the influence of the type of substituents in the polymer chain on the degradation temperature. A series of novel polycarbonates were designed differing from each other by the groups attached at the alpha and beta carbon atoms. Thermal behavior was characterized by thermogravimetrical analyses. The polymers undergo rapid and complete thermolysis at different degradation temperatures depending on the structure. The degradation products were separated by gas chromatography and analyzed by mass spectroscopy. The ratio of formed dienes in the product distribution depends on the heating rate. Furthermore, density functional theory calculations were performed on a series of model compound systems for the polycarbonates under study, in particular carbonate systems differing by the groups attached at the alpha and beta carbons. The study proves that the thermal degradation route can be controlled by tailoring the polymer backbone structure. Moreover, ab initio calculations provide further insight into the microscopic ingredients that govern the degradation process and associated reaction rates.

Ab Initio Studies of Thermal Syn-Elimination Reactions in Carbonates:  Effect of Structure on Reactivity

V. Van Speybroeck, Y. Martele, E. Schacht, M. Waroquier
Journal of Physical Chemistry A
106 (51), 12370–12375
2002
A1

Abstract 

Thermal elimination reactions in carbonates are investigated from a theoretical point of view with density functional theory methods to obtain insight into the reaction mechanism and structural factors that influence the kinetics. Carbonate systems are good model systems for the kinetics of thermal degradable polycarbonates. Special attention is given to the influence of para-substituents placed either at Cα or Cβ. The results enable prediction of ρ values of the Hammett equation and confirm earlier experimental data.

Micropatterning of polyurethanes with lasers

Y. Martele, K. Callewaert, I. Swennen, K. Naessens, R. Baets, V. Van Speybroeck, M. Waroquier, H. Van Aert, P. Dierickx, E. Schacht
Polymer International
51(11), 1172–1177
2002
A1

Abstract 

The micropatterning of a series new poly(carbonate-urethanes) with IR and excimer lasers is discussed. A series of segmented polyurethanes consisting of a soft segment and a hard segment was prepared. The soft segment, a thermodegradable polycarbonate diol, degrades by a syn-elimination at higher temperature. The hard segment was selected as to increase the sensitivity of the polymers for UV excimer laser ablation. The thermal and mechanical properties of the segmented polyurethanes (SPU) were investigated. By varying the building blocks in the polymer (soft and hard segments), the ablation properties were studied in terms of absorption coefficient and threshold value. Polymers with an aromatic chain-extender and an diisocyanate showed the highest absorption coefficient at wavelengths of 248 and 193 nm. Irradiation of these polymers led to cavities with high dimensional quality, sharp edges and no accumulation of degradation products near the cavities (no debris formation). Ablation with an IR laser led to a decrease in film thickness of the polymer deposited on a substrate. This was investigated with FTIR/ATR analysis and atomic force microscopy. Debris formation was found near the cavities. The differentiation of polarity between the exposed and unexposed areas was not efficient enough to use them as a coating for printing plates.

Ab Initio and Experimental Study on Thermally Degradable Polycarbonates:  The Effect of Substituents on the Reaction Rates

V. Van Speybroeck, M. Waroquier, Y. Martele, E. Schacht
JACS (Journal of the American Chemical Society)
123 (43), 10650–10657
2001
A1

Abstract 

Thermal elimination reactions on polycarbonates are investigated from both theoretical and experimental points of view, to obtain insight into the microscopic aspects that influence the reaction mechanism and rates. In particular, attention is focused on the influence of the type of substituents in the polymer chain on the reaction rates. Ab initio density functional theory calculations are performed on a series of model compound systems for the polycarbonates under study, in particular carbonates differing by the groups attached at the α and β carbon atoms. Reactants, products, and transition states are optimized at the B3LYP/6-311g** level of theory. The structures of the activated complex give insight into the mechanistic details of this type of Ei elimination reactions. The Cα−O bond dissociates before the Cβ−H bond, developing some carbocation character in the transition state on the Cα atom. The kinematics of the thermal decomposition reactions have been studied by means of transition state theory by construction of the microscopic partition functions. It turns out that the rates of the Ei elimination reactions are increased by the presence of those substituents on the Cα and Cβ carbon atoms which are stabilizing the carbocation character in the transition state. In a second part, degradation temperatures have been experimentally measured for some polycarbonates through thermogravimetric analysis. It is investigated whether the relative rates of the model compound carbonate systems are representative of the behavior of the thermal degradation temperatures in polycarbonates. The study as presented here proves that ab initio calculations on small model systems, which are representative for the active area of the degradation process in polycarbonates, can provide insight into the principal ingredients that govern the reaction rates.

Ab initio and experimental study on thermally degradable polycarbonates: The effect of substituents on the reaction rates

Poster

Conference / event / venue 

9th International Conference on the Applications of the Density Functional Theory in Chemistry and Physics
Madrid, Spain
Monday, 10 September, 2001 to Friday, 14 September, 2001
Subscribe to RSS - Y. Martele